Clover Winter Friends Card Kit

Here’s a project that is a little different from what I normally do which made it all that more fun.  I’ll explain a little more below.  This is also a card kit, Clover Winter Friends Card Kit, for one lucky person since there is only one kit left.

The stamp is Clover Winter Friends from Little Miss Muffet Stamps. My goal was to eliminate all the white space around the stamped image.  I could do this by coloring around the image or by fussy cutting … I chose the fussy cutting and then decided to do something fun with her wings too. 

You can see how I layered and assembled the card.  I used foam dots to pop up the top layer and also the image itself.  The diecut is Birds on a Wire Metal Die, also from Little Miss Muffet Stamps.

I cut out the image and even clipped off her wings.  I usually don’t use a black marker to go around the cut edge but this time I did.  Since I wasn’t going to have the white base, I wanted to make sure the thickens of the paper didn’t stand out.  Check out below how I did the wings, which were placed on the card before I added Clover.

I stamped the wings twice on clear plastic and cut them out so I could layer them. This allowed me to use the ground plus a white gel pen for snow and to keep it separate from the image.  The wings were covered with Stickles glitter and I bent them a little at the base so they stood out from the card.  However, before I layered them on the card I also stamped the image, in black, on the decorative paper.  This helped to position the image too.